LinuxCNC for the bare bones beginner - Part 1
Re: LinuxCNC for the bare bones beginner - Part 1
There is a long thread on the old forum that resulted in a couple specially built puppy/dog iso's specifically for cnc
I dump you into the middle of that thread here
https://oldforum.puppylinux.com/viewtopic.php?p=807550
LinuxCNC (EMC2) on Puppy (for search engines)
Μακάριοι οι καθαροί στην καρδιά * επειδή, θα δουν τον Θεό.
-
rockedge
- Site Admin
- Posts: 6543
- Joined: Mon Dec 02, 2019 1:38 am
- Location: Connecticut,U.S.A.
- Has thanked: 2749 times
- Been thanked: 2624 times
- Contact:
Re: LinuxCNC for the bare bones beginner - Part 1
LinuxCNC is the reason I made full real time kernels for Puppy Linux.
Heard huge 5.4.70-rt40 was a good performer in this regard.
Re: LinuxCNC for the bare bones beginner - Part 1
There is a 64-bit 5.4.70 RT kernel hidden here as well as other versions both 32-bit & 64-bit
https://rockedge.org/kernels
Μακάριοι οι καθαροί στην καρδιά * επειδή, θα δουν τον Θεό.
-
rockedge
- Site Admin
- Posts: 6543
- Joined: Mon Dec 02, 2019 1:38 am
- Location: Connecticut,U.S.A.
- Has thanked: 2749 times
- Been thanked: 2624 times
- Contact:
Re: LinuxCNC for the bare bones beginner - Part 1
@dogcat yes I made all of those kernels. 5.4.70-rt40 was so far really good for audio work and LinuxCNC and another good one is 4.19.82-rt30.
I have reports that indicate that both perform well with audio video work and 5.4.70-rt40 worked well with LinuxCNC