BionicPup Realtek 8125 (wired) or 8811CU (WiFi) pet/kernel

[MSG]

Help!!!
I have been using puppy_bionicpup64_8.0-uefi as an alternative operating system for some time and I am very satisfied. I recently changed the motherboard and have a Realtek 8125 Gigabit Gaming Ethernet adapter. I also have a Realtek 8811CU WiFi USB adapter. I would like help, if anyone has a pet or kernel for one of these adapters or another simple method to be able to connect to the Internet. I tried with the Windows drivers but without result. I'm not that good at recompiling the kernel with the respective drivers.
Thank you!

[ozsouth]

@MSG - welcome to the kennels! I will assume you're using the default 4.19.23 64bit kernel & make a wireless driver .pet shortly. To check the kernel, in a terminal run: uname -r

LATER: driver .pet is here: https://www.mediafire.com/file/dn96qpis ... 3.pet/file

This is a combo 8811-8821cu driver, so hopefully ok. Use at own risk.

After download, with your puppy booted up & wifi adaptor inserted, click on .pet in filemanager.
Wait 10 sec after install & try to connect. If successful, must save on exiting puppy to retain driver.

[MSG]

Thank you very much! I installed pet and configured the 5GHz network with Frisbee. 90 Mbps with a Realtek 8811 taken from Aliexpress is not bad.