Discussion, talk and tips
https://forum.puppylinux.com/
hello,
i installed busterdog in flashdisk it works
my broblem is how save my work after shut it down
what i do
but when i restarting it ask me couldn't find the changes file
how to fix this problem?
I'd try to create the save file manually or use a save folder. You should have a utility called "Create savefile"
Save folder is better for most cases.
Thank you for your reply
Can you explain to me how to use a save folder?
What tool did you use to install it to the flash drive or how did you do it???
i burn it in flashdik using Iso To USB Software is it the correct method
I'm newbie to LINUX
I'm not familiar with that particular install program. There are so many.
I think the fastest way to success is for you to manually create the changes.dat file and put it in /live on your flash disk.
I'm 90% sure that should just work.
edit: I was wrong.
Can you give me the steps how can i create the changes.dat file and how to put it in /live on my flash disk
becaue i am novice and i want to use th linux OS
edit: ignore this. I
'm kind of going blind, but try this.
*********************
Find the application "Savefile Creator" in the menu and run it.
You will get this window.
Create a save file and put it in the /live directory of your flash drive.
I'd make it at least 1 Gb (1000 Mb) and 2 Gb wouldn't hurt.
I suspect that TC00's "ISO to USB" burning tool has left the flash drive in read-only state.
So the Savefile Creator tool failed, even though it reported success.
I would use Rufus instead to make the flash drive.
rcrsn51 wrote: Mon Jul 31, 2023 12:49 pmI suspect that TC00's "ISO to USB" burning tool has left the flash drive in read-only state.
So the Savefile Creator tool failed, even though it reported success.
...
Yes, I think too (read-only) looking at @TC00's screenshot (/mnt/sr0/live as data).
It should give a message that save-file creation failed, probably it didn't, sorry about that.
i will use a Rufus and i try again