Discussion, talk and tips
https://forum.puppylinux.com/
I always do USB installs to boot from.
Decided I better try a CD burn install of F96-CE_1 to see if it will boot from a CD.
I cannot get it to boot.
Anyone got it to boot from a CD install?
For me it does not even act like it is trying to read what is on the CD.
Never get anything, no boot menu, nothing!
@bigpup Oh oh.... this should not be happening. I can boot into a QEMU virtual machine and create a save folder after formatting the virtual hard drive but that is from the ISO. I'll look at this as well 
In Fossapup64 9.5, you should be able to use Menu>Mulitimedia>Pburn, use F96-CE_1.iso as the source. Note: the resulting CD will only boot in MBR legacy mode.
wizard
OH, we are having fun now!
Thanks wizard!
I just noticed the PM from you.
I will be back and let you know how it goes for me.
Sorry, but I will have to do this tomorrow.
OH, we are having fun now!
Yes we are 
Look at that test matrix, we need an emoji for heavy drinking 
wizard
I am going to mark this solved.
But not sure what fixed it.
Telling me that the F96-CE ISO cannot burn a UEFI CD helped.
I re-burned a new CD.
Made sure to burn at a low speed.
Went into the computers UEFI setup and made sure it was set to boot in legacy mode.
It was, but I reset it anyway. Doing a new UEFI setup save and reboot.
After doing these things.
Got it to boot from this new CD.
Could have been a bad ISO burn to the CD.
Maybe resetting the UEFI setup and making a new setup save.
I hate UEFI and the boot in this mode or that mode settings.
Well this UEFI bios also had a setting to select legacy +UEFI boot mode.
That is suppose to auto adjust to the type of boot mode you are trying to ask it to do.
Anyway the F96-CE CD also booted OK with that boot mode setting.
So on this computers UEFI setup for boot mode.
Legacy mode worked.
Legacy+UEFI mode worked.
But not UEFI mode.
Learned a new UEFI boot mode setting for my computer legacy+UEFI 