I made a 64bit 6.1.115, Non-Usrmerge, Aufs/Overlayfs Kernel.
Has many input devices & more drivers set, with rtw88-8821ce unset. Runs my new Ideapad Slim 1i well.
THIS HAS A SPECTRE v2 FIX ENABLED.
Is in both Ubuntu and Slacko compatible flavours. CANNOT be used for Jammypup64 & later (USRMERGE Pups),
UNLESS these Ubuntu derivative kernel-modules & kernel_sources (& non-usrmerge fdrvs) are run through
a converter like this one: viewtopic.php?p=116744#p116744
'aoex' means aufs, overlayfs & either non-usrmerge (default) or usrmerge if converted. x = extras.
Has Voluntary Preemption, older ntfs-3g, vmd & Blake2s builtin, has 300Hz frequency. Is TCP_SACK mitigated.
Is mostly Spectre/Meltdown mitigated (needs microcode too - see viewtopic.php?p=9658#p9658).
Used gcc 10.2.0 & glibc 2.30. Used 2018 Kernel-Kit Master, with only my essential-for-operation fixes.
Although this should work on standard older puppies (probably bionicpup64 & later) as is, to use it with overlayfs, need a specifc initrd.gz, or (if your puppy is more recent, like S15Pup64-22.12) have punionfs=overlay in the grub/syslinux linux/kernel line.
Briefly tested, OK in s15pup64_22.12+4 (aufs & overlayfs). Use at own risk.
For best results when using a savefile/savefolder, it is advisable to have that on an ext3 (or 4) partition.
wl & rtl8821ce wireless drivers are in forum Drivers section.
NOTE: many broadcom devices can use in-kernel b43 drivers. fdrv below has newer broadcom firmware to work with that.
Once downloaded, expand in an empty folder with tar -jxvf, & rename kernel-modules.sfs-6.1.115-64oz-nr-aoex to zdrv ... (same as one to be replaced) & rename vmlinuz-6.1.115-64oz-hf-nr-aoex to vmlinuz & then substitute for originals.
Important Note: when switching kernels, if you have an ...initmodules.txt file (i.e. fossapup64initmodules.txt or similar, in same folder as puppy sfs), must delete it before first boot into new kernel. Otherwise it may try to load modules that don't exist, causing failure.
Notes for Overlayfs: either kernel derivative below works on any system. Devx, if named in same convention as puppy sfs for that pup, will load on boot, if in the same folder as puppy sfs. If devx loaded on the fly, compiling will fail, so best to have a separate install just for compiling, with no savefile/savefolder, naming kernel sources as ydrv & rebooting.
Also, savefolders/files cannot be shared by aufs & overlayfs, due to different structures.
Ubuntu derivative: https://www.mediafire.com/file/az5kjhoq ... r.bz2/file
Slacko derivative: https://www.mediafire.com/file/mbjjoyoj ... r.bz2/file
Kernel Sources: https://www.mediafire.com/file/4bac40hb ... x.sfs/file
Kernel Headers: https://www.mediafire.com/file/g9ub65ga ... 4.sfs/file
My 28oct24 med fdrv (65mb): https://www.mediafire.com/file/facaov76 ... 4.sfs/file
My 28oct24 lowmed fdrv (36mb): https://www.mediafire.com/file/twyvf8eb ... 4.sfs/file