Request for help with FossaPup 96-CE and internet connection.
I'm using a standard modem to connect (via copper) to the internet. Ethernet cable between my desktop and the modem. Copper to the exchange.
Until recently I used uPupBB32 and 64. The connection wizard was simplicity itself.
To set up the network - click the SNS (I think it means "simple network setup") - wait a few moments - and 'connection made'.
After the initial connection I could disconnect and reconnect by clicking the small icon at the lower right of the screen. I often left uPupBB-64 running overnight, but with the screen off and internet disconnected. In the morning - click the small icon mentioned a moment ago - bingo! Re-connected. I can't remember if I had to right/left click - it always worked.
Now - with FossaPup CE-9v6
Today we had a storm. This means the terminal box - at ground level in the street - is full of water. The internet is flakey. It will run for 30 or 60 minutes and then I must re-boot the modem and re-connect.
Again, using uPupBB64 - that was easy-peasy.
Now, with Fossa 64-CE the process is obscure. The previous simplicity is gone.
Please, can anyone direct me to a 'help' page that describes the process of disconnecting/reconnecting to the modem for FossaPup CE?
Thank you.
cobaka.
). Conman is the best at quickly establishing an internet connection. But a PITA once it looses it. So I use Network Wizard as the default. Takes a little more work than Frisbee or SNS to configure but seems to be less fragile.