Page 2 of 2
Re: How to install Puppy to flash drive?
Posted: Sat Sep 26, 2020 6:18 am
by InvalidUsername
oui wrote: ↑Fri Sep 25, 2020 9:17 pm
can your installation use the rest of the memory capacity of your USB memory (normally, unetbootin permit that automatically!)?
I will check! I think so.
Re: How to install Puppy to flash drive?
Posted: Sat Sep 26, 2020 6:19 am
by InvalidUsername
williwaw wrote: ↑Fri Sep 25, 2020 10:42 pm
InvalidUsername wrote: ↑Fri Sep 25, 2020 8:18 pm
Finally I tried again with unetbootin on MX Linux...
Now typing this message from Puppy Live USB
live?, or with persistence? fossapup?
Fossapup "live with persistence"!
Can someone mention on Puppy official website not to use Balena but Rufus or Unetbootin instead?
Re: How to install Puppy to flash drive?
Posted: Sat Sep 26, 2020 6:53 pm
by williwaw
sometimes, "live" means without persistence. puppys primary distinction when installed to an internal disk, is it's advantages with the preferred frugal install over a the more common "full" install.
Puppys and dogs have no single official website, as there are many different projects. This site is as close as it comes for many discussions and the subforum
viewforum.php?f=146 might be the defacto home for fosssapup. see
http://puppylinux.com/ Other projects that have subforums here also have a "home" elsewhere. It's a bit confusing.