Looking for 3d printer programs

Moderator: Forum moderators

3 posts • Page 1 of 1

boof: Posts: 568; Joined: Sat Aug 15, 2020 9:17 am; Been thanked: 8 times

Post by boof » Thu Aug 01, 2024 1:30 pm

somerhing that works, pls elgoo neptune 4 pro. for this or fossapup64-9.5

Last edited by Flash on Sat Nov 02, 2024 4:11 am, edited 1 time in total.
Reason: Clarify the subject line

vtpup: Posts: 746; Joined: Sat Aug 15, 2020 2:34 pm; Location: Republic of Vermont; Has thanked: 198 times; Been thanked: 172 times; Contact:
Contact vtpup

Website

Post by vtpup » Fri Nov 01, 2024 7:14 pm

I use Cura.

Appimage works on F96-CE r4 , and I believe I also had run it on BionicPup64 in the past.

HP Envy Laptop 17t-cr100
Fossapup F-96 CE rev 4
Huge kernel: huge-6.1.8-fossapup64
My homemade foam boat:
www.youtube.com/watch?v=4sDubB0-REg

rockedge: Site Admin; Posts: 6571; Joined: Mon Dec 02, 2019 1:38 am; Location: Connecticut,U.S.A.; Has thanked: 2779 times; Been thanked: 2650 times; Contact:
Contact rockedge

Website

Post by rockedge » Fri Nov 01, 2024 10:43 pm

I use CHITUBOX on F96-CE_4 slicing for a MARS 3

Post Reply

3 posts • Page 1 of 1